Click here

NOISE FILTER REMOVAL

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  2. Click here

    REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  3. Click here

    REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  4. Click here

    DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

    Click here

  5. Click here

    REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  6. Click here

    REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  7. Click here

    REMOVE RADIO SETTING CONDENSER (for High Mounted Stop Light)

    Note:

    When a terminal cover is removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.


    1. B0066QG

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. B0066OU

      Disengage the claw and pull out the cover as shown in the illustration.

    4. B0067CB

      Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    5. B00667W

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    6. Remove the terminal cover from the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.

  8. Click here

    REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH (for Window Defogger)

    Click here

  9. Click here

    REMOVE RADIO SETTING CONDENSER (for Window Defogger)

    Note:

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. B006641

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. B00684S

      Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.

    4. B00689H

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.