RADIO ANTENNA CORD INSTALLATION

PROCEDURE

1. Click here

   INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY

   
   

   1. Engage each clamp.

   2. Connect the 2 connectors to install the No. 5 antenna cord sub-assembly.

2. Click here

   INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

   Click here

3. Click here

   INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

   
   

   1. Engage each clamp.

   2. w/o Digital Audio Broadcasting Antenna:

      
      

      1. Install the 2 bolts.

   3. w/ Digital Audio Broadcasting Antenna:

      
      

      1. Install the 3 bolts.

   4. Connect each connector to install the No. 2 antenna cord sub-assembly.

   5. 

      Install the floor carpet to its original position as shown in the illustration.

   6. Engage the 2 guides.

   7. Install the 4 clips.

4. Click here

   INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

   Click here

5. Click here

   INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

6. Click here

   INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH

   Tip:

   Use the same procedure as for the LH side.

   Click here

7. Click here

   INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH

   Tip:

   Use the same procedure as for the LH side.

8. Click here

   INSTALL FRONT DOOR SCUFF PLATE RH

   Tip:

   Use the same procedure as for the LH side.

9. Click here

   INSTALL REAR SEAT ASSEMBLY

   Click here

10. Click here

    INSTALL FRONT SEAT ASSEMBLY LH

    Click here

11. Click here

    INSTALL FRONT SEAT ASSEMBLY RH

    Tip:

    Use the same procedure as for the LH side.

12. Click here

    INSTALL ANTENNA CORD SUB-ASSEMBLY

    
    

    1. Engage each clamp.

    2. Connect each connector to install the antenna cord sub-assembly.

13. Click here

    INSTALL NO. 1 CONSOLE BOX DUCT

    Click here

14. Click here

    INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

15. Click here

    INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

16. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here