Click here

AUDIO AND VISUAL SYSTEM(w/o Parking Assist Monitor System), Diagnostic DTC:B1579

Click here
Click here
DTC Code DTC Name
B1579 Voice Recognition Microphone Disconnected
Click here

DESCRIPTION

The radio receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Microphone signal is lost

  • Map light assembly

  • Telephone microphone assembly

  • Radio receiver assembly

  • Harness or connector
Table 1. *a Map Light Assembly (Telephone Microphone Assembly) *b Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    INSPECT RADIO RECEIVER ASSEMBLY


    1. A01VOBUC98
      *a

      Component with harness connected

      (Radio Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O70-19 (MIN-) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))


    1. Disconnect the O70 radio receiver assembly connector.

    2. Disconnect the W4 map light assembly (telephone microphone assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O70-6 (SNS2) - W4-1 (SNS2) Always Below 1 Ω
      O70-19 (MIN-) - W4-2 (MCO-) Always Below 1 Ω
      O70-6 (SNS2) - Body ground Always 10 kΩ or higher
      O70-19 (MIN-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    INSPECT MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)


    1. Remove the map light assembly (telephone microphone assembly).

      Click here

    2. A01VNJVC20
      *a

      Component without harness connected

      (Map Light Assembly (Telephone Microphone Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (SNS2) - 2 (MCO-) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

  4. Click here

    REPLACE TELEPHONE MICROPHONE ASSEMBLY


    1. Replace the telephone microphone assembly.

      Click here

    2. Clear the DTCs.

      Click here


      1. Body Electrical > Navigation System > Clear DTCs


    3. Recheck for DTCs and check that no DTCs are output.


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG