AUDIO AND VISUAL SYSTEM(w/ Parking Assist Monitor System) Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. START DIAGNOSTIC MODE


    1. Enter diagnostic mode and check if the "Service Menu" screen can be displayed.

      Click here

      OK
      Diagnostic mode can be activated.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  2. CHECK PANEL SWITCH (OPERATION CHECK)


    1. B0066HY

      Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.

      Click here

    2. Operate the abnormal switch and check if the switch status is correctly displayed.

      OK
      The switch status is correctly displayed as operated.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  3. REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK)


    1. Activate self-diagnostic mode.

      Click here

    2. A01VN3YC01
      *a Switch Illumination
      *b Touchpad

      Check switch operation.


      1. Operate the touchpad diagonally from the upper right to the lower left to turn the switch illumination off.

        Note

        Since the touchpad may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the touchpad in self-diagnostic mode.

      2. With the switch illumination turned off, press each switch of the remote touch (remote operation controller assembly) and check that the switch illumination turns on.

        Result
        Result Proceed to
        Self-diagnostic mode cannot be activated. A
        Some switches do not turn on the switch illumination when they are pressed.
        All switches turn on the switch illumination when they are pressed. B

    A
    B