Click here

AUDIO AND VISUAL SYSTEM(for 7 Inch Display), Diagnostic DTC:B1579

Click here
Click here
DTC Code DTC Name
B1579 Voice Recognition Microphone Disconnected
Click here

DESCRIPTION

The radio receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Microphone signal is lost.

  • Telephone microphone assembly

  • Radio receiver assembly

  • Harness or connector
Table 1. *a Telephone Microphone Assembly *b Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly may not operate normally.

Click here

PROCEDURE


  1. Click here

    INSPECT RADIO RECEIVER ASSEMBLY


    1. B0067SBC32
      *a

      Component with harness connected

      (Radio Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O147-22 (MIN-) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)


    1. Disconnect the O147 radio receiver assembly connector.

    2. Disconnect the W14 telephone microphone assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O147-25 (SNS2) - W14-3 (SNS2) Always Below 1 Ω
      O147-22 (MIN-) - W14-4 (MCO-) Always Below 1 Ω
      O147-25 (SNS2) or W14-3 (SNS2) - Body ground Always 10 kΩ or higher
      O147-22 (MIN-) or W14-4 (MCO-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    INSPECT TELEPHONE MICROPHONE ASSEMBLY


    1. Remove the telephone microphone assembly.

      Click here

    2. B006697C01
      *a

      Component without harness connected

      (Telephone Microphone Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (SNS2) - 4 (MCO-) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG