Click here

AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU

Click here
Click here
DTC Code DTC Name
  Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
Click here

DESCRIPTION

This circuit includes the navigation ECU and radio receiver assembly.

Table 1. *1 Navigation ECU *2 Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the O148 radio receiver assembly connector.

    2. Disconnect the O150 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O148-28 (REV2) - O150-19 (REV2) Always Below 1 Ω
      O148-28 (REV2) or O150-19 (REV2) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR