Click here

AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Stereo Jack Adapter Light does not Illuminate

Click here
Click here
DTC Code DTC Name
  Stereo Jack Adapter Light does not Illuminate
Click here

DESCRIPTION

Power is supplied to the No. 1 stereo jack adapter assembly illumination from the radio receiver assembly.

Table 1. *a No. 1 Stereo Jack Adapter Assembly *b Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly may not operate normally.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER ASSEMBLY ILLUMINATION POWER SOURCE)


    1. Disconnect the O166 and O151 No. 1 stereo jack adapter assembly connectors.

    2. B00681KC26
      *a

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O166-1 (USV1) - Body ground Engine switch on (ACC) 5 V
      O151-8 (ACC) - Body ground Engine switch on (ACC) 11 to 14 V
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the O165 radio receiver assembly connector.

    2. Disconnect the O166 No. 1 stereo jack adapter assembly connector.

    3. B0066YKC38
      *a

      Front view of wire harness connector

      (to Radio Receiver Assembly)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O166-1 (USV1) - O165-1 (USV1) Always Below 1 Ω
      O166-1 (USV1) or O165-1 (USV1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the O146 radio receiver assembly connector.

    2. Disconnect the O151 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O146-16 (ACC) - O151-8 (ACC) Always Below 1 Ω
      O146-16 (ACC) or O151-8 (ACC) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE RADIO RECEIVER ASSEMBLYClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR