Click here

AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Does not Play even after Bluetooth Audio Mode is Selected

Click here
Click here
DTC Code DTC Name
  Does not Play even after Bluetooth Audio Mode is Selected
Click here

CAUTION / NOTICE / HINT

Note:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly or navigation ECU may not operate normally.

Tip:

Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in-vehicle device.

Click here

PROCEDURE


  1. Click here

    CHECK OPERATION


    1. Check if the portable player operates normally.

      OK
      The portable player operates normally.
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK AUDIO SETTINGS


    1. Set volume, fader and balance to the initial values and check that the sound is normal.

      OK
      Audio system returns to normal.
      Tip:

      Sound quality adjustment measures vary according to the type of amplifier.

      Result
      Proceed to
      OK
      NG

  3. Click here

    CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL


    1. Check if the "Bluetooth" audio player plays normally on another "Bluetooth" audio compatible vehicle of the same model.

      OK
      "Bluetooth" audio player plays normally.
      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      MALFUNCTION IN PORTABLE PLAYER