Click here

AUDIO AND VISUAL SYSTEM(w/o Parallel Parking Assist Function) Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

Click here
Click here
DTC Code DTC Name
  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter
Click here

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio receiver assembly via this circuit.

Table 1. *1 (Shielded) *2 No. 1 Stereo Jack Adapter Assembly *3 Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the O70 radio receiver assembly connector.

    2. Disconnect the O66 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O70-13 (VV+) - O66-8 (VV+) Always Below 1 Ω
      O70-14 (VV-) - O66-9 (VV-) Always Below 1 Ω
      O70-13 (VV+) - Body ground Always 10 kΩ or higher
      O70-14 (VV-) - Body ground Always 10 kΩ or higher
      O70-12 (SG) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR