AUDIO AND VISUAL SYSTEM(w/o Parallel Parking Assist Function) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

   
   

   1. Disconnect the O70 radio receiver assembly connector.

   2. Disconnect the O66 No. 1 stereo jack adapter assembly connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition O70-25 (ADPG) - O66-1 (ADPG) Always Below 1 Ω O70-11 (AGND) - O66-7 (AGND) Always Below 1 Ω O70-26 (VAR+) - O66-2 (VAR+) Always Below 1 Ω O70-28 (VAL+) - O66-3 (VAL+) Always Below 1 Ω O70-27 (VA-) - O66-4 (VA-) Always Below 1 Ω O70-25 (ADPG) - Body ground Always 10 kΩ or higher O70-11 (AGND) - Body ground Always 10 kΩ or higher O70-26 (VAR+) - Body ground Always 10 kΩ or higher O70-28 (VAL+) - Body ground Always 10 kΩ or higher O70-27 (VA-) - Body ground Always 10 kΩ or higher

      Result
      Proceed to OK NG

   
   
   • OK

     PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

   • NG

     REPAIR OR REPLACE HARNESS OR CONNECTOR