AUDIO AND VISUAL SYSTEM(w/ Parallel Parking Assist Function) Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   START DIAGNOSTIC MODE

   
   

   1. Enter diagnostic mode and check if the "Service Menu" screen can be displayed.

      Click here

      OK
      Diagnostic mode can be activated.

      Result
      Proceed to OK NG

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK PANEL SWITCH (OPERATION CHECK)

   
   
   1. 

      Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.

      Click here

   2. Operate the abnormal switch and check if the switch status is correctly displayed.

      OK
      The switch status is correctly displayed as operated.

      Result
      Proceed to OK NG

   
   
   • OK

     REPLACE RADIO RECEIVER ASSEMBLYClick here

   • NGClick here

     GO TO STEP 3

3. Click here

   REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK)

   
   

   1. Activate self-diagnostic mode.

      Click here

   2. 

      *a	Switch Illumination
      *b	Touchpad

      Check switch operation.

      
      

      1. Operate the touchpad diagonally from the upper right to the lower left to turn the switch illumination off.

         Note:

         Since the touchpad may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the touchpad in self-diagnostic mode.

      2. With the switch illumination turned off, press each switch of the remote touch (remote operation controller assembly) and check that the switch illumination turns on.

         Result
         Result Proceed to Self-diagnostic mode cannot be activated. A Some switches do not turn on the switch illumination when they are pressed. All switches turn on the switch illumination when they are pressed. B

   
   
   • A

     REPLACE REMOTE OPERATION CONTROLLER ASSEMBLYClick here

   • B

     REPLACE RADIO RECEIVER ASSEMBLYClick here