HEATED STEERING WHEEL CONTROLLER(w/ Lane Departure Alert System) INSTALLATION

PROCEDURE

1. Click here

   INSTALL STEERING VIBRATION AND HEATER ECU

   
   

   1. Connect the connector to the steering vibration and heater ECU.

   2. Install the steering vibration and heater ECU to the lower steering wheel boss cover with the 2 screws.

      0.835 N*m

      9 kgf*cm

      7 in.*lbf

      Note:

      If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.

   3. 

      Engage the 2 claws to install the lower steering wheel boss cover to the steering wheel assembly.

      Note:

      If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.

   4. Install the screw.

      0.835 N*m

      9 kgf*cm

      7 in.*lbf

   5. Connect the 2 connectors to the steering vibration and heater ECU.

   6. Engage the guide to install the wire harness to the lower steering wheel cover.

2. Click here

   INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

   Click here

3. Click here

   INSTALL STEERING PAD SWITCH ASSEMBLY

   Click here

4. Click here

   INSTALL CRUISE CONTROL MAIN SWITCH

   Click here

5. Click here

   ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

6. Click here

   INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

   Click here

7. Click here

   INSTALL STEERING WHEEL ASSEMBLY

   Click here