HEATED STEERING WHEEL CONTROLLER(w/ Lane Departure Alert System) REMOVAL

PROCEDURE

1. Click here

   REMOVE STEERING WHEEL ASSEMBLY

   Click here

2. Click here

   REMOVE CRUISE CONTROL MAIN SWITCH

   Click here

3. Click here

   REMOVE STEERING PAD SWITCH ASSEMBLY

   Click here

4. Click here

   REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

   Click here

5. Click here

   REMOVE STEERING VIBRATION AND HEATER ECU

   
   
   1. 

      Disengage the guide to remove the wire harness from the lower steering wheel cover.

   2. Disconnect the 2 connectors.

   3. 

      *1	Heater Thermistor

      Remove the screw.

   4. Disengage the 2 claws of the lower steering wheel boss cover.

      Note:

      If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.

      Tip:

      Do not remove the lower steering wheel boss cover from the steering wheel sub-assembly. Loosen the lower steering boss cover.

   5. 

      Remove in this Direction

      Remove the 2 screws.

   6. Move the steering vibration and heater ECU until it reaches a position where the connector can be disconnected.

   7. Disconnect the connector to remove the steering vibration and heater ECU from the lower steering wheel cover.