Click here

TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Note:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Click here

PROCEDURE


  1. Click here

    INSTALL TILT AND TELESCOPIC SWITCH


    1. Engage the claw to install the tilt and telescopic switch.

    2. Connect the tilt and telescopic connector to the tilt and telescopic switch.

    3. Connect the airbag connector to the spiral cable with sensor sub-assembly.

  2. Click here

    INSTALL STEERING COLUMN COVER (for Lower Side)


    1. Engage the 2 claws to install the steering column cover (lower).

    2. Install the 3 screws.

  3. Click here

    ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  4. Click here

    INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  5. Click here

    INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. Click here

    CHECK STEERING WHEEL CENTER POINT

  7. Click here

    INSTALL HORN BUTTON ASSEMBLY

    Click here

  8. Click here

    CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here