Click here

TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Click here

PROCEDURE


  1. Click here

    CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS

    Click here

  2. Click here

    ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. Click here

    REMOVE HORN BUTTON ASSEMBLY

    Click here

  4. Click here

    REMOVE STEERING WHEEL ASSEMBLY

    w/ Lane Departure Alert System:Click here

    w/o Lane Departure Alert System:Click here

  5. Click here

    REMOVE STEERING COLUMN COVER (for Lower Side)


    1. B00678Y

      Remove the 3 screws.

    2. B0067TI

      Disengage the 2 claws and remove the steering column cover (lower).

  6. Click here

    REMOVE TILT AND TELESCOPIC SWITCH


    1. B006626C01
      *a Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. B0065YK

      Disconnect the tilt and telescopic connector from the tilt and telescopic switch.

    3. Disengage the claw and pull out the tilt and telescopic switch.