Click here

REAR BRAKE FLEXIBLE HOSE REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

If the left and right rear flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE REAR WHEEL

    Click here

  2. Click here

    DRAIN BRAKE FLUID

    Note:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. Click here

    REMOVE REAR FLEXIBLE HOSE


    1. A01FOC6

      Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.

    2. A01FO6N

      Using a union nut wrench, disconnect the brake tube while holding the rear flexible hose with a wrench.

      Note:

      • Do not kink or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

    3. Remove the clip and rear flexible hose.