REAR BRAKE REASSEMBLY

PROCEDURE

1. Click here

   TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

   Tip:

   Fully tighten the rear disc brake bleeder plug after bleeding the system.

2. Click here

   INSTALL CYLINDER BOOT

   
   
   1. 

      *a	Large	*b	Small
      *c	Do not apply grease	-	-
      	Forward Rotational Direction of Rear Disc	-	-

      Install a new cylinder boot into the groove of the disc brake piston as shown in the illustration.

      Note:
      

      • Because there are two cylinder sizes, be sure to use the correct size boot for each disc brake piston as shown in the illustration.

      • Securely install the cylinder boot into the groove of the rear disc brake piston.

      • Do not apply any grease to any part where the cylinder boot touches the rear disc brake cylinder assembly as shown in the illustration.

   2. 

      *1	Cylinder boot
      *2	Rear Disc Brake Piston

      Push in the disc brake piston and install the cylinder boot to the rear disc brake cylinder assembly.

      Note:
      

      • Do not forcibly push the disc brake piston into the rear disc brake cylinder assembly.

      • Securely install the cylinder boot into the groove of the rear disc brake cylinder assembly.

   3. Use the same procedure to install the remaining cylinder boots.