TELEMATICS SYSTEM(w/ Telematics Transceiver for G-BOOK) Emergency Call Switch Illumination Circuit

WIRING DIAGRAM

A01VODXE20
*a Telematics Transceiver
*b Map Light Assembly

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK.

Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY)


    1. Disconnect the O65 telematics transceiver connector.

    2. Disconnect the W4 map light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O65-9 (SLED) - W4-5 (RRID) Always Below 1 Ω
      O65-26 (SIG-) - W4-9 (GND3) Always Below 1 Ω
      O65-9 (SLED) - Body ground Always 10 kΩ or higher
      O65-26 (SIG-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT MAP LIGHT ASSEMBLY


    1. Remove the map light assembly.

      Click here

    2. Connect 4 1.5 V dry-cell batteries in series.

    3. A01VMSAC08
      *a

      Component without harness connected

      (Map Light Assembly)

      Connect a positive lead from the batteries to terminal 5 (RRID), and a negative lead to terminal 9 (GND3) of the map light assembly connector.

    4. Check if the illumination for the emergency call switch comes on.

      OK
      Illumination for the emergency call switch comes on.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE TELEMATICS TRANSCEIVER Click here

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here