NAVIGATION ECU INSTALLATION

PROCEDURE

1. PRECAUTION

   Note

   
   

   • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

   
   

   • A communication malfunction DTC may be stored.

   • The radio receiver assembly or navigation ECU may not operate normally.

   • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio receiver assembly.

2. INSTALL NAVIGATION ECU

3. INSTALL RADIO RECEIVER ASSEMBLY

4. INSTALL NO. 2 RADIO BRACKET

   Click here

5. INSTALL NO. 1 RADIO BRACKET

   Click here

6. INSTALL NO. 1 NAVIGATION WIRE

   
   

   1. Connect the 2 connectors to install the No. 1 navigation wire.

7. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

8. INSTALL CONSOLE PANEL SUB-ASSEMBLY

   Click here

9. INSTALL FRONT PANEL GARNISH RH

   Click here

10. INSTALL FRONT PANEL GARNISH LH

    Click here

11. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

    Click here

13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here