NAVIGATION ECU REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:
   

   • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

   • 
     

     • A communication malfunction DTC may be stored.

     • The radio receiver assembly or navigation ECU may not operate normally.

   • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio receiver assembly.

2. Click here

   REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

3. Click here

   REMOVE INSTRUMENT PANEL FINISH PANEL END LH

   Click here

4. Click here

   REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

5. Click here

   REMOVE FRONT PANEL GARNISH LH

   Click here

6. Click here

   REMOVE FRONT PANEL GARNISH RH

   Click here

7. Click here

   REMOVE CONSOLE PANEL SUB-ASSEMBLY

   Click here

8. Click here

   REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

9. Click here

   REMOVE NO. 1 NAVIGATION WIRE

   
   
   1. 

      Disconnect the 2 connectors to remove the No. 1 navigation wire.

10. Click here

    REMOVE NO. 1 RADIO BRACKET

    Click here

11. Click here

    REMOVE NO. 2 RADIO BRACKET

    Click here

12. Click here

    REMOVE RADIO RECEIVER ASSEMBLY

13. Click here

    REMOVE NAVIGATION ECU