MULTI-DISPLAY REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. Click here

   CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. Click here

   REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. Click here

   DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

6. Click here

   REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

7. Click here

   REMOVE METER HOOD SUB-ASSEMBLY

   Click here

8. Click here

   REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

9. Click here

   REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET

   
   
   1. 

      Remove the 2 bolts.

   2. 

      Pull the multi-display assembly with bracket as shown in the illustration to disengage the 4 clips.

   3. 

      Disconnect each connector.

   4. Disengage the clamp and remove the multi-display assembly with bracket.

10. Click here

    REMOVE NO. 1 MULTI-DISPLAY BRACKET

    
    
    1. 

       Remove the 2 screws and No. 1 multi-display bracket.

11. Click here

    REMOVE MULTI-DISPLAY ASSEMBLY