NAVIGATION RECEIVER REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Click here

   Note:
   

   • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

     Click here

   • w/ Telematics Transceiver:

     A Hard Disk Drive (HDD) is built into the radio receiver assembly to store music data of sound library function. Therefore, care must be taken for the following points when handling the radio receiver assembly.

   • w/ Telematics Transceiver:

     When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

4. Click here

   REMOVE INSTRUMENT PANEL FINISH PANEL END LH

   Click here

5. Click here

   REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

6. Click here

   REMOVE FRONT PANEL GARNISH LH

   Click here

7. Click here

   REMOVE FRONT PANEL GARNISH RH

   Click here

8. Click here

   REMOVE CONSOLE PANEL SUB-ASSEMBLY

   Click here

9. Click here

   REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

10. Click here

    REMOVE NO. 1 RADIO BRACKET

    Click here

11. Click here

    REMOVE NO. 2 RADIO BRACKET

    Click here

12. Click here

    REMOVE HARD DISK DRIVE (w/ Telematics Transceiver)

    Click here

13. Click here

    REMOVE RADIO RECEIVER ASSEMBLY