TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

    Note


    • Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.


    1. Connect the connector to the tire pressure warning ECU and receiver.

    2. Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.

    3. B0067XAC03
      *A for Type A
      *B for Type B

      Install the tire pressure warning ECU and receiver with the bolt.

      Torque:
      for Type A
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }
      for Type B
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      There are 4 types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

  2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  5. INSTALL LAP BELT OUTER ANCHOR COVER (for LH Side)

    Click here

  6. INSTALL REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  7. CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

    Click here

  8. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  9. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  10. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  11. REGISTER TRANSMITTER ID

    Click here

  12. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  13. PERFORM INITIALIZATION

    Click here