REAR SHOCK ABSORBER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT TRIM COVER

    Click here

  2. REMOVE REAR WHEEL

    Click here

  3. REMOVE REAR SUSPENSION ARM COVER

    Click here

  4. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

    Click here

  5. SEPARATE REAR STEERING TIE ROD ASSEMBLY

    Click here

  6. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  7. REMOVE REAR STABILIZER LINK ASSEMBLY

    Click here

  8. SEPARATE REAR SHOCK ABSORBER ASSEMBLY (for Lower Side)

    Click here

  9. REMOVE REAR COIL SPRING

    Click here

  10. REMOVE REAR UPPER COIL SPRING INSULATOR

    Click here

  11. REMOVE REAR LOWER COIL SPRING INSULATOR

    Click here

  12. REMOVE REAR SHOCK ABSORBER ASSEMBLY (for Upper Side)


    1. B0067AG

      Disconnect the connector.

    2. Disengage the wire harnesses clamp from the actuator harness clamp.

    3. B00661Q

      Disengage the 2 clamps and remove the actuator harness clamp from the vehicle body.

    4. B0067G3

      Remove the 3 nuts and rear shock absorber assembly from the vehicle body.

  13. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY


    1. Secure the rear actuator support bracket of the rear shock absorber assembly between aluminum plates in a vise.

      Note

      Do not overtighten the vise.

    2. B006682

      Using a 17 mm deep socket wrench, remove the rear support to rear shock absorber nut and rear actuator support bracket from the rear shock absorber assembly.

      Note


      • Do not pinch the wire harness when removing the rear support to rear shock absorber nut with the deep socket wrench.

      • When inserting the wire harness and connector into the deep socket wrench, do not excessively bend the wire harness.

    3. Remove the rear shock absorber cushion washer, rear No. 1 shock absorber cushion, rear suspension support assembly and rear No. 2 shock absorber cushion from the rear shock absorber assembly.

  14. REMOVE REAR NO. 1 SPRING BUMPER


    1. Remove the rear No. 1 spring bumper from the rear shock absorber assembly.