Click here

REAR UPPER ARM INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL REAR NO. 2 UPPER CONTROL ARM ASSEMBLY


    1. Temporarily install the rear No. 2 upper control arm assembly to the rear suspension member sub-assembly with the bolt, nut and washer.

      Note:

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

    2. B00657LN01

      Set the rear No. 2 upper control arm assembly in the tightening position as shown in the illustration.

      Reference Length (A)
      39.2 mm (1.54 in.)

    3. Fully tighten the nut.

      150 N*m 1530 kgf*cm 111 ft.*lbf
      Note:

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

  2. Click here

    INSTALL REAR NO. 1 UPPER CONTROL ARM ASSEMBLY


    1. Temporarily install the rear No. 1 upper control arm assembly to the rear suspension member sub-assembly with the bolt, nut and washer.

      Note:

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

    2. B0067PON02

      Set the rear No. 1 upper control arm assembly in the tightening position as shown in the illustration.

      Reference Length (A)
      29.7 mm (1.17 in.)

    3. Fully tighten the nut.

      150 N*m 1530 kgf*cm 111 ft.*lbf
      Note:

      Because the bolt has its own stopper, do not turn the bolt. Tighten the nut with the bolt secured.

  3. Click here

    INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here