SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE

1. Click here

   INSTALL ABSORBER CONTROL ECU

   
   

   1. Install the absorber control ECU with the bolt and nut.

      8.5 N*m

      87 kgf*cm

      75 in.*lbf

      Note:
      

      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

   2. Connect the 2 connectors.

   3. Engage the 2 clamps and install the connector holder to the vehicle body.

   4. Return the floor carpet to its original position.

2. Click here

   INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

   Click here

3. Click here

   INSTALL FRONT DOOR OPENING TRIM COVER RH

   Tip:

   Use the same procedure for the RH side and LH side.

   Click here

4. Click here

   INSTALL FRONT DOOR SCUFF PLATE RH

   Tip:

   Use the same procedure for the RH side and LH side.

   Click here

5. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:
   

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

     Click here

   • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

     Click here