Click here

DIFFERENTIAL MOUNT CUSHION INSTALLATION

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    1. A01FKHSC01
      *a SST bolt location *b 0° +/- 3°
      B00679M Front of the Vehicle - -

      Using SST, install a new rear No. 1 differential mount cushion.

      09527-17011 09570-24011
      Note:

      • Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.

      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolts.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

      • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.

      Tip:

      Install the 2 SST bolts to the 2 SST holes as shown in the illustration.

  2. Click here

    INSTALL REAR NO. 2 DIFFERENTIAL MOUNT CUSHION


    1. A01FMKMC01
      *a SST bolt location *b 0° +/- 3°
      B00679M Front of the Vehicle - -

      Using SST, install a new rear No. 2 differential mount cushion.

      09527-17011 09570-24011
      Note:

      • Make sure that the rear No. 2 differential mount cushion is aligned within 3° from the center.

      • Temporarily install the rear No. 2 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolt.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 2 differential mount cushion.

      • Do not tilt the bolt of SST.

      Tip:

      Install the SST bolt to the SST hole as shown in the illustration.

  3. Click here

    INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (for LSD)

    Click here

  4. Click here

    INSTALL TORQUE VECTORING DIFFERENTIAL FDU (FINAL DRIVE UNIT) (for Torque Vectoring Differential)

    Click here