DIFFERENTIAL MOUNT CUSHION REMOVAL

PROCEDURE

1. Click here

   REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY (for LSD)

   Click here

2. Click here

   REMOVE TORQUE VECTORING DIFFERENTIAL FDU (FINAL DRIVE UNIT) (for Torque Vectoring Differential)

   Click here

3. Click here

   REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

   
   
   1. 

      *a	SST bolt location	-	-
      	Front of the Vehicle	-	-

      Using SST, remove the rear No. 1 differential mount cushion.

      09527-17011

      09570-24011

      Note:
      

      • Before using SST, apply grease to the SST bolts.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

      • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.

      • Do not bring SST (09527-17011) into contact with the rear suspension member sub-assembly.

      Tip:

      Install the 2 SST bolts to the 2 SST holes as shown in the illustration.

4. Click here

   REMOVE REAR NO. 2 DIFFERENTIAL MOUNT CUSHION

   
   
   1. 

      *a	SST bolt location	-	-
      	Front of the Vehicle	-	-

      Using SST, remove the rear No. 2 differential mount cushion.

      09316-12010

      09570-24011

      Note:
      

      • Before using SST, apply grease to the SST bolt.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09316-12010) contacts the entire circumference of the rear No. 2 differential mount cushion.

      • Do not tilt the bolt of SST.

      • Do not bring SST (09316-12010) into contact with the rear suspension member sub-assembly.

      Tip:

      Install the SST bolt to the SST hole as shown in the illustration.