TORQUE VECTORING DIFFERENTIAL ECU(for Torque Vectoring Differential) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER

    w/o Spare Tire: Click here

    w/ Spare Tire: Click here

  4. REMOVE SPARE WHEEL COVER TRAY (w/o Spare Tire)

    Click here

  5. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  6. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  7. REMOVE FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  9. SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  10. REMOVE TORQUE VECTORING DIFFERENTIAL ECU ASSEMBLY


    1. Disengage the 2 clamps.

      B0066H0C01
      *a Connector (A) *b Connector (B)
      *c Lock - -

    2. Disconnect the 3 connectors (A).

    3. Using a screwdriver, release the 2 locks and disconnect the 2 connectors (B) as shown in the illustration.

      Tech Tips

      When disconnecting the connector with lock lever, pull out the lock of the lock lever, disengage the claw and turn the lock lever to disconnect the connector as shown in the illustration.

    4. Remove the 3 bolts and torque vectoring differential ECU assembly.