REAR DIFFERENTIAL CARRIER ASSEMBLY(for LSD) INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Note


    • Do not damage the installation surface when installing the rear differential carrier assembly.

    • The remaining oil may leak out when installing the rear differential carrier assembly.

    • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

    • Install the bolts with the rear differential carrier assembly secured.


    1. B00670GC01
      *a Attachment

      Support the rear differential carrier assembly with 2 attachments or equivalent tools as shown in the illustration.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

      Note

      Use attachments or equivalent tools to keep the rear differential carrier assembly level.

    2. Install the 2 rear upper differential mount stoppers to the rear differential carrier assembly.

    3. Temporarily install the rear suspension member sub-assembly to the rear differential carrier assembly.

    4. Temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers and 2 new bolts (A).

      B0065DWN01

    5. Using a 12 mm hexagon socket wrench, temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with 3 new bolts (B) and (C).

      Tech Tips

      Before installing the bolts (B) and (C), make sure that there is no clearance between the rear differential carrier assembly and rear differential mount cushion.

    6. Using a 12 mm hexagon socket wrench, tighten the 2 bolts (B).

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

      Note

      Do not tilt the sleeve or deform the rubber of the rear differential mount cushion when tightening the bolts (B).

    7. Using a 12 mm hexagon socket wrench, tighten the bolt (C).

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

      Note

      Do not tilt the sleeve or deform the rubber of the rear differential mount cushion when tightening the bolt (C).

    8. Tighten the 2 bolts (A).

      Torque:
      Bolt Type A
      95.1 N*m  { 970 kgf*cm, 70 ft.*lbf }
      Bolt Type B
      88.9 N*m  { 907 kgf*cm, 66 ft.*lbf }

  2. INSTALL REAR SUSPENSION ARM BRACKET ASSEMBLY

    Click here

  3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  4. ADD DIFFERENTIAL OIL

    Click here

  5. INSPECT FOR DIFFERENTIAL OIL LEAK