REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL(for Torque Vectoring Differential) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR DRIVE SHAFT ASSEMBLY

    Click here

  2. REMOVE REAR DRIVE SHAFT OIL SEAL


    1. A01FM5SC01
      *1 Rear Drive Shaft Oil Seal

      Using SST, remove the rear drive shaft oil seal.

      SST
      09308-00010

  3. INSTALL REAR DRIVE SHAFT OIL SEAL


    1. A01FNGYC01
      *1 Rear Drive Shaft Oil Seal
      *a Oil Seal Installation Depth

      Using SST and a hammer, install a new rear drive shaft oil seal.

      SST
      09649-17010
      09950-70010   ( 09951-07150 )
      Oil Seal Installation Depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note


      • Make sure to check the identification marks on the rear drive shaft oil seals before installation because the part numbers differ between the left and right sides.

      • To ensure a proper seal, evenly tap in the rear drive shaft oil seal.

      • When installing the rear drive shaft oil seal, tap it in until the outer surface is flush with the torque transfer module.

      • Make sure the difference between the maximum and minimum measured values of the oil seal installation depth is less than 0.58 mm (0.0228 in.), as a greater difference may lead to fluid leaks.

  4. INSTALL REAR DRIVE SHAFT ASSEMBLY

    Click here