TORQUE VECTORING DIFFERENTIAL SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

    System See Procedure
    Parking Assist Monitor System (w/ Parallel Parking Assist Function)

    Click here

    Parking Assist Monitor System (w/o Parallel Parking Assist Function)
    Air Conditioning System

  2. TROUBLESHOOTING PRECAUTIONS


    1. When there is a malfunction with terminal contact points or part installation problems, removal and installation of the suspected parts may return the system to normal either completely or temporarily.

    2. In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as DTC output and Freeze Frame Data, and record it before disconnecting any connector or removing and installing parts.

    3. Since the system may be influenced by malfunctions in systems other than the torque vectoring differential system, be sure to check for DTCs in other systems.

  3. CAN COMMUNICATION SYSTEM PRECAUTIONS


    1. The CAN communication system is used for communication between the skid control ECU, steering angle sensor, yaw rate and acceleration sensor and other ECUs. If there is a malfunction in a CAN communication line, corresponding DTCs in the communication line are output.

    2. If any CAN communication DTCs are output, repair the malfunction, then troubleshoot the torque vectoring differential system while communication is normal.

    3. In order to enable CAN communication, a specific type of wiring is used for the CAN communication lines. The wiring used for each communication line is a twisted pair of wires that have an equal length.

      A bypass wire should not be used because the data being transmitted will be corrupted.

  4. CHASSIS DYNAMOMETER PRECAUTION


    1. Enter check mode or remove the TVD fuse to disable TVD control when using a chassis dynamometer.

      Note

      Secure the vehicle with lock chains for safety.

      Tech Tips

      TVD control will be disabled by entering check mode.

    2. Activating Check Mode

      Note


      • Check mode will be canceled when the engine switch is turned off. Make sure to enter check mode again if the inspection is continued after the engine switch is turned off.


      • Do not drive the vehicle with check mode selected.


      1. Turn the engine switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Enter the following menus: Chassis / TVD / Utility / Check Mode.


        Chassis > TVD > Utility
        Tester Display
        Check Mode

    3. Cancel Check Mode


      1. Turn the engine switch off to cancel check mode.

  5. REPLACEMENT PRECAUTION


    1. If the torque vectoring differential ECU assembly or torque vectoring differential FDU (Final Drive Unit) has been replaced, perform "Learning Value Initialization".

      Click here

    2. If the torque transfer module motor sub-assembly has been replaced or removed and installed, perform "Learning Value Initialization".

      Click here