STEERING KNUCKLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. SEPARATE FRONT SKID CONTROL SENSOR WIRE

    A01FMF1

    1. Disconnect the pad wear indicator wire connector from the front skid control sensor wire clamp.

    2. Disconnect the front skid control sensor wire connector from the front axle hub sub-assembly.

    3. Remove the bolt and separate the front skid control sensor wire from the steering knuckle.

  3. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


    1. A01FNDX

      Disconnect the pad wear indicator wire assembly from the clamp of front disc brake dust cover.

    2. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

      Note

      Use wire or an equivalent tool to keep the front disc brake caliper assembly from hanging by the front flexible hose.

  4. REMOVE FRONT DISC

    Click here

  5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  6. REMOVE FRONT DISC BRAKE DUST COVER

    A01FOG6

    1. Remove the 4 bolts and front disc brake dust cover from the steering knuckle.

  7. SEPARATE TIE ROD ASSEMBLY

    Click here

  8. SEPARATE FRONT LOWER BALL JOINT ASSEMBLY


    1. A01FO2K

      Remove the 2 bolts and separate the front lower ball joint assembly from the steering knuckle.

  9. REMOVE STEERING KNUCKLE


    1. A01VMVP

      Remove the clip and nut.

    2. A01FM5MC03
      *a 1 mm (0.0394 in.)

      Install SST to the front upper suspension arm assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02060 )

      Note

      Check that the clearance measurement between SST and the steering knuckle is 1 mm (0.0394 in.).

    3. Using SST, remove the steering knuckle from the front upper suspension arm assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02010 )
      A01FLEVC03
      *a Molybdenum Grease Application Area *b Place wrench here
      *c Center Nut *d Spacer
      *e String - -

      CAUTION:

      Apply molybdenum grease to the threads and end of the SST bolt.

      Note


      • Install SST with the center nut so that (A) and (B) shown in the illustration are parallel. Otherwise, the front upper suspension arm dust cover may be damaged.

      • Be sure to place a wrench on the part indicated in the illustration.

      • Do not damage the ball joint dust cover.

      • Do not damage the steering knuckle.

      • Make sure that SST is securely positioned on the spacer.

      • Be sure to tighten the string firmly to secure SST to the front upper suspension arm assembly to prevent SST from falling off.

      Tech Tips

      If the steering knuckle spacer has come off, replace the steering knuckle with a new one.