Click here

FRONT AXLE HUB BOLT REPLACEMENT

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE FRONT WHEEL

    Click here

  2. Click here

    SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


    1. B0065W8

      Disconnect the pad wear indicator wire connector from the front skid control sensor wire.

    2. A01FNDX

      Disconnect the pad wear indicator wire assembly from the clamp of front disc brake dust cover.

    3. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

      Note:

      Use wire or an equivalent tool to keep the front disc brake caliper assembly from hanging by the front flexible hose.

  3. Click here

    REMOVE FRONT DISC

    Click here

  4. Click here

    REMOVE FRONT AXLE HUB BOLT


    1. B0065ZYC03
      *a Service Nut

      Temporarily install 2 service nuts to the front axle hub bolts as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 12.0 mm (0.472 in.)
      Thread pitch: 1.5 mm (0.0591 in.)
      Note:

      Install the service nuts to prevent damage to the front axle hub bolts.

    2. Using SST and a screwdriver or an equivalent tool to hold the front axle hub, remove the front axle hub bolt.

      09611-12010
      Note:

      Do not damage the threads of the front axle hub bolts.

  5. Click here

    INSTALL FRONT AXLE HUB BOLT


    1. Temporarily install a new front axle hub bolt to the front axle hub.

    2. B0067PVC03
      *a Service Nut
      *b Washer

      Install a washer and service nut to the new front axle hub bolt as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 12.0 mm (0.472 in.)
      Thread pitch: 1.5 mm (0.0591 in.)
      Tip:

      Recommended washer thickness is 5 mm (0.197 in.) or more.

    3. Using a screwdriver or an equivalent tool to hold the front axle hub, install the front axle hub bolt by tightening the service nut.

      Note:

      • Install the service nuts to prevent damage to the front axle hub bolts.

      • Do not damage the threads of the front axle hub bolts.

    4. Remove the 3 service nuts and washer from the 3 front axle hub bolts.

  6. Click here

    INSTALL FRONT DISC

    Click here

  7. Click here

    INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY


    1. Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

      135 N*m 1377 kgf*cm 100 ft.*lbf
      Note:

      Do not twist the front flexible hose when installing the front disc brake caliper assembly.

    2. B0066ULC01
      *a 0° +/- 30°

      Check that the bleeder plug cap of the pad wear indicator wire assembly is installed to the front disc brake caliper assembly as shown in the illustration.

      Note:

      Perform this check without the pad wear indicator wire assembly installed to the front disc brake dust cover clamp.

    3. Install the pad wear indicator wire assembly to the clamp of front disc brake dust cover.

    4. Connect the pad wear indicator wire connector to the front skid control sensor wire.

  8. Click here

    INSTALL FRONT WHEEL

    Click here