TCM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  4. REMOVE ENGINE ROOM ECU COVER

    Click here

  5. REMOVE TCM


    1. B0066FQC01
      *a Junction Connector

      Disconnect the engine wire harness connector (A) as shown in the illustration.

    2. Disconnect the engine wire harness connector (B) as shown in the illustration.

    3. Disengage the claw and disconnect the junction connector from the connector holder.

    4. B00672G

      Using a screwdriver, disengage the claw.

    5. Disconnect the grommet and connector holder from the engine room ECM box.

    6. B006787

      Disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    7. B00660U

      Disconnect the 2 TCM connectors.

    8. B0066IJ

      Remove the 2 nuts and TCM from the engine room ECM box.

      Note

      If the TCM has been struck or dropped, replace it.

    9. B0066V6

      Remove the 4 screws and 2 brackets from the TCM.