SHIFT PADDLE SWITCH INSPECTION

PROCEDURE

1. Click here

   INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

   
   
   1. 

      *a	Component without harness connected (Shift Paddle Switch (Transmission Shift Switch Assembly) LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Table 1. Shift Paddle Switch (Transmission Shift Switch Assembly) LH: Tester Connection Condition Specified Condition 2 (ECC) - 1 (SDN) "-" continuously pulled Below 2.5 Ω Released 1 MΩ or higher

      If the result is not as specified, replace the shift paddle switch (transmission shift switch assembly) LH.

   2. 

      *a	Component without harness connected (Shift Paddle Switch (Transmission Shift Switch Assembly) RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Table 2. Shift Paddle Switch (Transmission Shift Switch Assembly) RH: Tester Connection Condition Specified Condition 3 (SUP) - 2 (ECC) "+" continuously pulled Below 2.5 Ω Released 1 MΩ or higher

      If the result is not as specified, replace the shift paddle switch (transmission shift switch assembly) RH.