SHIFT LEVER ADJUSTMENT

PROCEDURE


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  3. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. B0067VTC01
      *a Lever

      Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.

    3. B0065JQC01
      *1 Transmission Control Shaft Lever RH
      *a P
      *b R
      *c N

      Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

    4. B0065SUC01
      *a Lever
      B00679M Rear of the vehicle

      Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.

    5. Temporarily install the nut to the lever of the transmission floor shift assembly.

    6. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

      Torque:
      12.8 N*m  { 131 kgf*cm, 9 ft.*lbf }

      Note

      Do not push the lever of the transmission floor shift assembly too hard.

  4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  6. INSPECT SHIFT LEVER POSITION

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK

    Click here