TRANSMISSION WIRE INSPECTION

PROCEDURE

1. *a Component without harness connected (Transmission Wire (ATF Temperature Sensor))
   Click here

   INSPECT TRANSMISSION WIRE

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection ATF Temperature Specified Condition 8 (OIL) - Body ground Always 10 kΩ or higher 9 (E2) - Body ground Always 10 kΩ or higher

      Tip:

      If the result is not as specified following at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

      Standard Resistance
      Tester Connection ATF Temperature Specified Condition 8 (OIL) - 9 (E2) 10°C (50°F) 5 to 8 kΩ 8 (OIL) - 9 (E2) 25°C (77°F) 2.5 to 4.5 kΩ 8 (OIL) - 9 (E2) 110°C (230°F) 0.22 to 0.28 kΩ

      If the result is not as specified, replace the transmission wire (ATF temperature sensor).