CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION

• The ECM turns on the SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication.

• The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed.

• The cruise SET indicator light circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the engine switch on (IG).

   3. Turn the GTS on.

   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   5. Perform "Active Test" according to the display on the GTS.

      
      Body Electrical > Combination Meter > Active Test

      Tester Display	Measurement Item	Control Range	Diagnostic Note
      Indicat. SET	Cruise control SET indicator	ON or OFF	-

      
      Body Electrical > Combination Meter > Active Test

      Tester Display
      Indicat. SET

      OK
      The cruise control SET indicator comes on or goes off.

      Result
      Proceed to OK NG

   
   

   NG

   GO TO METER / GAUGE SYSTEM Click here

   OK

2. READ VALUE USING GTS

   
   

   1. Enter the following menus: Powertrain / Cruise Control / Data List.

   2. Read the Data List according to the display on the GTS.

      
      Powertrain > Cruise Control > Data List

      Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
      SET/COAST Switch	-/SET switch signal	ON or OFF	ON: -/SET switch on OFF: -/SET switch off	-

      
      Powertrain > Cruise Control > Data List

      Tester Display
      SET/COAST Switch

      OK
      When the cruise control switch (-/SET switch) is operated, the display changes as shown above.

      Result
      Proceed to OK NG

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPLACE ECM Click here