ENGINE OIL COOLER(for Air Cooled Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • B0066KJC01
      *a Upper Engine Oil Cooler Bracket
      *b Do not loosen

      If the bolts of the upper engine oil cooler bracket are loosened, the oil cooler assembly may move out of position and interfere with the front bumper assembly. Do not loosen the bolts of the upper engine oil cooler bracket.

    • When the oil cooler assembly (for air cooled type) has been removed/installed or the oil cooler hose sub-assembly has been disconnected/reconnected, check the engine oil level after warming up the engine oil to between 100°C and 120°C to open the thermostat between the engine and oil cooler assembly (for air cooled type).

      B0066AWC06
      *1 thermostat (thermostat housing assembly) *2 oil cooler hose sub-assembly
      *3 oil cooler assembly (for air cooled type) - -

    Tech Tips

    Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature.


    Powertrain > Engine > Data List
    Tester Display
    Engine Oil Temperature

  2. REMOVE FRONT WHEEL LH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  4. DRAIN ENGINE OIL

    Click here

  5. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  6. REMOVE INLET ENGINE OIL COOLER AIR DUCT


    1. B00650QC01
      *a Clamp
      *b Guide

      Disengage the clamp to disconnect the wire harness from the inlet engine oil cooler air duct.

    2. Remove the 2 bolts.

    3. Disengage the guide to remove the inlet engine oil cooler air duct from the oil cooler assembly.

  7. REMOVE OIL COOLER ASSEMBLY


    1. B00689J

      Remove the 2 bolts and disconnect the oil cooler hose sub-assembly from the oil thermostat housing assembly.

    2. B0067JZ

      Remove the 2 O-rings from the oil cooler hose sub-assembly.

    3. B00670Y

      Remove the 2 nuts and disconnect the oil cooler hose sub-assembly from the No. 1 oil cooler bracket.

    4. B0067KE

      Remove the 2 bolts and 3 clips to disconnect the outlet engine oil cooler air duct from the front fender liner LH.

    5. B006519

      Remove the 4 nuts and oil cooler assembly with outlet engine oil cooler air duct from the vehicle body.

    6. B00682A

      Remove the 3 bolts and disconnect the oil cooler hose sub-assembly from the oil cooler assembly.

    7. B006579

      Remove the 3 O-rings from the oil cooler hose sub-assembly.

    8. B006650

      Remove the 2 bolts and outlet engine oil cooler air duct from the oil cooler assembly.

    9. B0065M9

      Remove the 2 nuts, 2 clips and lower engine oil cooler bracket from the oil cooler assembly.

      Note

      Do not loosen the bolts of the upper engine oil cooler bracket.

      B0066KJC01
      *a Upper Engine Oil Cooler Bracket
      *b Do not loosen