CANISTER(w/o Canister Pump Module) REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. Click here

   DISCHARGE FUEL SYSTEM PRESSURE

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. Click here

   REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

5. Click here

   REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

6. Click here

   REMOVE FRONT DOOR SCUFF PLATE RH

   Tip:

   Use the same procedure as for the LH side.

   Click here

7. Click here

   DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

   Tip:

   Use the same procedure as for the LH side.

   Click here

8. Click here

   REMOVE REAR SIDE SEATBACK ASSEMBLY RH

   Tip:

   Use the same procedure as for the LH side.

   Click here

9. Click here

   REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

   Tip:

   Use the same procedure as for the LH side.

   Click here

10. Click here

    REMOVE REAR FLOOR SERVICE HOLE COVER

    Click here

11. Click here

    REMOVE CANISTER (FUEL TANK VENT TUBE ASSEMBLY)

    Click here

12. Click here

    REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY

    Click here