INJECTOR DRIVER INSTALLATION

PROCEDURE

1. Click here

   INSTALL INJECTOR DRIVER

   Note:
   

   • Be careful not to drop or strike the injector driver.

   • The injector driver is grounded at the 4 bolts and 2 nuts. To ensure that it is grounded, clean the installation surfaces of the injector driver and engine before installing the injector driver.

   
   

   1. Temporarily install the 2 injector drivers with the 4 bolts and 2 nuts.

   2. Tighten the 4 bolts and 2 nuts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   3. 

      *a	Lock Lever

      Connect the 2 injector driver connectors.

   4. Connect the 6 connectors (with lock) to the 2 injector drivers and move the lock lever to engage the lock of each connector (with lock) as shown in the illustration.

      Note:

      Securely connect the connectors (with lock) to the injector driver and engage the lock.

2. Click here

   INSTALL V-BANK COVER SUB-ASSEMBLY

   Click here

3. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here