INJECTOR DRIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  4. REMOVE INJECTOR DRIVER


    1. B0067NLC01
      *a Lock Lever
      *b Lock
      *c Connector (with Lock)

      Push the lock and move the lock lever of each connector (with lock) as shown in the illustration and disconnect the 6 connectors (with lock) from the 2 injector drivers.

    2. Disconnect the 2 injector driver connectors.

    3. B00658YC01
      B0067U9 Bolt
      B00679M Nut

      Remove the 4 bolts, 2 nuts and 2 injector drivers.

      Note

      Be careful not to drop or strike the injector driver.