BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE

1. Click here

   INSTALL BRAKE PEDAL PAD

   
   

   1. Install the brake pedal pad to the brake pedal support assembly.

2. Click here

   INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

   
   

   1. Install the brake pedal support assembly with the 4 nuts.

      12.7 N*m

      130 kgf*cm

      9 ft.*lbf

   2. Connect the connector and engage the 2 clamps.

3. Click here

   INSTALL PUSH ROD PIN

   
   
   1. 

      Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the push rod pin.

   2. 

      Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

      Note:

      Be sure to install the push rod pin in the correct direction.

4. Click here

   INSTALL STOP LIGHT SWITCH ASSEMBLY

   
   

   1. Temporarily install the stop light switch assembly to the brake pedal support assembly.

      Click here

      Tip:

      Fully tighten the stop light switch assembly lock nut after adjusting the brake pedal height.

5. Click here

   INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT

   Click here

6. Click here

   INSPECT AND ADJUST BRAKE PEDAL

   Click here