ROLL RATE AND VERTICAL ACCELERATION SENSOR REMOVAL

PROCEDURE

1. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

2. Click here

   REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

3. Click here

   REMOVE ROLL RATE AND VERTICAL ACCELERATION SENSOR

   
   
   1. 

      Disengage the 2 wire harness clamps from the bracket.

   2. Disconnect the connector from the roll rate and vertical acceleration sensor.

   3. 

      Remove the 2 nuts and roll rate and vertical acceleration sensor.

      Note:
      

      • Do not drop the roll rate and vertical acceleration sensor.

      • If the roll rate and vertical acceleration sensor is dropped, replace it with a new one.

4. Click here

   REMOVE BRACKET

   
   
   1. 

      Remove the 2 screws and bracket from the instrument panel safety pad sub-assembly.