Click here

FRONT SPEED SENSOR INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

  • The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor is malfunctioning, replace the front axle hub sub-assembly.

Click here

PROCEDURE


  1. Click here

    INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Click here

    Tip:

    • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

    • The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor is malfunctioning, replace the front axle hub sub-assembly.

  2. Click here

    INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. Click here

    INSPECT FRONT AXLE HUB RUNOUT

    Click here

  4. Click here

    INSTALL FRONT DISC

    Click here

  5. Click here

    INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. Click here

    INSTALL FRONT SKID CONTROL SENSOR WIRE


    1. for LH Side:


      1. Connect the connector to install the front skid control sensor wire LH.

      2. Install the sensor clamp to the vehicle body with the bolt.

        6.0 N*m 61 kgf*cm 53 in.*lbf
        Note:

        Do not twist the front skid control sensor wire when installing it.

      3. Engage the clamp to the front No. 1 stabilizer bracket LH.

        Note:

        Do not twist the front skid control sensor wire when installing it.

    2. for RH Side:


      1. Connect the connector to install the front skid control sensor wire RH.

      2. Install the sensor clamp to the vehicle body with the bolt.

        6.0 N*m 61 kgf*cm 53 in.*lbf
        Note:

        Do not twist the front skid control sensor wire when installing it.

      3. Engage the 2 clamps to the front No. 1 stabilizer bracket RH and vehicle body.

        Note:

        Do not twist the front skid control sensor wire when installing it.

    3. Return the front fender liner to its original position.

    4. Install the 2 sensor clamps to the front shock absorber assembly and vehicle body with the 2 bolts.

      6.0 N*m 61 kgf*cm 53 in.*lbf
      Note:

      Do not twist the front skid control sensor wire when installing it.

    5. Install the sensor clamp to the steering knuckle with the bolt.

      8.5 N*m 87 kgf*cm 75 in.*lbf
      Note:

      Do not twist the front skid control sensor wire when installing it.

    6. Connect the front skid control sensor wire connector to the front axle hub sub-assembly.

      Note:

      Do not twist the front skid control sensor wire when installing it.

    7. Connect the pad wear indicator wire connector to the front skid control sensor wire.

      Note:

      Do not twist the pad wear indicator wire when installing it.

  7. Click here

    INSTALL FRONT FENDER LINER


    1. Install the front fender liner with the screw.

  8. Click here

    INSTALL FRONT WHEEL

    Click here

  9. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  10. Click here

    CHECK FOR SPEED SENSOR SIGNAL

    Click here