FRONT SPEED SENSOR

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.
The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor is malfunctioning, replace the front axle hub sub-assembly.

PROCEDURE

Click here
PRECAUTION

Note:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
Click here
REMOVE FRONT WHEEL

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
SEPARATE FRONT FENDER LINER
1. Remove the screw and separate the front fender liner.

REMOVE FRONT SKID CONTROL SENSOR WIRE

*1	Pad Wear Indicator Wire
*2	Front Skid Control Sensor Wire

Disconnect the pad wear indicator wire connector from the front skid control sensor wire.

Disconnect the front skid control sensor wire connector from the front axle hub sub-assembly.
Remove the bolt and sensor clamp from the steering knuckle.
Remove the 2 bolts and 2 sensor clamps from the front shock absorber assembly and vehicle body.
Turn back the front fender liner.
for LH Side:
1. Disengage the clamp from the front No. 1 stabilizer bracket LH.
2. Remove the bolt and sensor clamp from the vehicle body.
3. Disconnect the connector to remove the front skid control sensor wire LH.
for RH Side:
1. Disengage the 2 clamps from the front No. 1 stabilizer bracket RH and vehicle body.
2. Remove the bolt and sensor clamp from the vehicle body.
3. Disconnect the connector to remove the front skid control sensor wire RH.

FRONT SPEED SENSOR REMOVAL