VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if CAN communication system DTCs are output.

      Click here

      Result
      Result Proceed to DTCs are not output. A DTCs are output. B

   
   
   • AClick here
   • B

     INSPECT CAN COMMUNICATION SYSTEMClick here

2. Click here

   PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)

   
   

   1. Select the Active Test using the GTS.

      Click here

      
      
      1. Chassis > ABS/VSC/TRC > Active Test

         Tester Display	Measurement Item	Control Range	Diagnostic Note
         Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Can be observed on the combination meter assembly

      2. 
         
         10. 
             
      
      
      1. Chassis > ABS/VSC/TRC > Data List

         Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
         Slip Indicator Light	Slip indicator light	ON or OFF	ON: Indicator light on OFF: Indicator light off	-

      2. 
         
         10. 
             
      
      
      1. Chassis > ABS/VSC/TRC > Active Test

         Active Test Display
         Slip Indicator Light

         Data List Display
         Slip Indicator Light

      2. 
         
         1. 
            
      3. 
         
         11. 
             
         12. 
             

   2. When performing the slip Indicator Light Active Test, check slip Indicator Light in the Data List.

      Result
      Result Proceed to Slip indicator light in the Data List does not change using the Active Test. A Slip indicator light in the Data List turns ON/OFF using the Active Test. B

      Tip:

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here

   
   
   • A

     REPLACE BRAKE ACTUATOR ASSEMBLY for LHD:Click here

     REPLACE BRAKE ACTUATOR ASSEMBLY for RHD:Click here

   • BClick here
3. Click here

   INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Turn the engine switch off.

   2. Perform an Active Test of the combination meter assembly using the GTS.

      Click here

      
      
      1. Body Electrical > Combination Meter > Active Test

         Tester Display
         Indicat. Lamp Slip

      2. 
         
         1. 
            
      3. 
         
         11. 
             

   3. Check the combination meter assembly.

      OK
      The slip indicator light turns on or off in accordance with the Active Test operation.

      Tip:

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here

      Result
      Proceed to OK NG

   
   
   • OK

     REPLACE BRAKE ACTUATOR ASSEMBLY for LHD:Click here

     REPLACE BRAKE ACTUATOR ASSEMBLY for RHD:Click here

   • NG

     INSPECT METER / GAUGE SYSTEMClick here