YAW RATE AND ACCELERATION SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL YAW RATE SENSOR BRACKET

   
   

   1. Engage the 2 claws and install the yaw rate sensor bracket.

      Tip:

      Install the yaw rate sensor bracket while avoiding the wire harness.

   2. Install the 3 bolts.

      8.5 N*m

      87 kgf*cm

      75 in.*lbf

   3. Engage the 2 wire harness clamps to the yaw rate sensor bracket.

2. Click here

   INSTALL YAW RATE SENSOR

   
   

   1. Install the yaw rate sensor with the 2 nuts.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:
      

      • Do not drop the yaw rate sensor.

      • If the yaw rate sensor is dropped, replace it with a new one.

   2. Connect the connector to the yaw rate sensor.

      Note:

      Make sure that the yaw rate sensor connector is connected securely.

   3. Engage the wire harness clamp to the yaw rate sensor bracket.

3. Click here

   INSTALL NO. 1 CONSOLE BOX DUCT

   Click here

4. Click here

   INSTALL CONSOLE BOX ASSEMBLY

   Click here

5. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

6. Click here

   PERFORM YAW RATE AND ACCELERATION SENSOR AND ROLL RATE AND VERTICAL ACCELERATION SENSOR ZERO POINT CALIBRATION

   Click here