Click here

VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1381

Click here
Click here Click here
DTC Code DTC Name
C1381 Acceleration Sensor Power Supply Voltage Malfunction
Click here

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) receives a sensor supply voltage malfunction signal from the yaw rate and acceleration sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1381 Acceleration Sensor Power Supply Voltage Malfunction At a vehicle speed of more than 3 km/h (2 mph), an acceleration sensor power source malfunction signal is received for 10 seconds or more.

  • Acceleration sensor power source circuit

  • Acceleration sensor (yaw rate and acceleration sensor)
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • When replacing the yaw rate and acceleration sensor, perform zero point calibration and store system information.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (IG TERMINAL)


    1. B0066ITC27
      *a

      Front view of wire harness connector

      (to Yaw Rate and Acceleration Sensor)

      Make sure that there is no looseness at the locking part and the connecting part of the connector.

    2. Disconnect the O81 yaw rate and acceleration sensor connector.

    3. Turn the engine switch on (IG).

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O81-4 (IG) - Body ground Engine switch on (IG) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)

  2. Click here

    CHECK HARNESS AND CONNECTOR (GND TERMINAL)


    1. A01VMNGC28
      *a

      Front view of wire harness connector

      (to Yaw Rate and Acceleration Sensor)

      Turn the engine switch off.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O81-1 (GND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)

  3. Click here

    RECONFIRM DTC


    1. Reconnect the O81 yaw rate and acceleration sensor connector.

    2. Clear the DTCs.

      Click here


      1. Chassis > ABS/VSC/TRC > Clear DTCs


    3. Turn the engine switch off.

    4. Start the engine.

    5. Perform a road test.

    6. Check if the same DTC is output.

      Click here


      1. Chassis > ABS/VSC/TRC > Trouble Codes


      Result
      Result Proceed to
      DTC C1381 is not output. A
      DTC C1381 is output. B
      Note:

      Check the yaw rate and acceleration sensor signal after replacement.

      Click here

      Tip:

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here